Passed SCEA II with 88%

hi

Finally I have acquired SCEA certificate.

I did first part two years ago but I was too busy (and too lazy) to complete the certification sooner.

In assignment I had created 11 sequence diagramms, class and component diagramms and also a deployment diagramm.

I used MagicDraw for UML which is quite decent tool because it supports UML 2.0 well but , of course, it has some drawbacks, too.

Maris
SCJP, SCWCD, SCBCD, SCEA

This report shows the total points that could have been awarded in each section and the actual amount of points you were awarded. This information is provided in order to give you feedback on your relative strengths on a section basis. The maximum number of points you could have received is 100, minimum to pass is 70.

Class Diagram (44 maximum) .......................... 39
Component Diagram (44 maximum) ...................... 37
Sequence/Colloboration Diagrams (12 maximum) ........ 12
[ May 30, 2007: Message edited by: Maris Orbidans ]

Congrats !

Can you please elaborate more on your diagrams and what you put into them ? Good score

My sequence diagrams were quite huge and detailed. The largest one had
21 participants and 85 messages. Actually I was concerned that they might be too big and too difficult to understand.

My class diagram is similar to that one in Mark's book - extended domain model and some session beans.

And components diagram contains all participants that are mentioned in sequence diagrams - delegates, locators, facades, EJB's , DAOs, the whole nine yards.

Congratulations,