ExamLab scjp6 installation

I previously had ExamLab scjp 5 running smoothly on my machine. I'm having trouble installing(launching) the ExamLab for SCJP6.
The ExamLab scjp setup runs fine and issues only start when the Microsoft Jet driver installation begins. I get asked if I'd like to keep some already existing Microsoft Jet drivers that were already installed in my machine because they are newer than the ones currently installing. I say yes and setup completes with sucessfully installed message. Only I can't launch the ExamLab Scjp6. Could somebody please assist?

Please try out the beta version: http://examlab.tk/beta/

Hallo Devaka,

I forgot to include that my machine is running on Windows XP. Do I delete pre-existing Microsoft Jet drivers and reinstall ExamLab Scjp6 afresh?

That beta version should work on 'any' version of Windows. It doesn't require the JET driver - you don't need to install, reinstall, or uninstall the JET driver

Thanks. It finally worked. Will definitely make donations after passing exam.

Devaka,

I was too quick to write that it works. Now I'm on the simulator's front page where on the right are Diagnostic exam, Practice exams and final exam. I want to start with the diagnostic exam, I click on it and nothing happens. On the left I get questions like "What do you think about out software?..." and Thank you for using Exam Lab. How does this software work?

Thanks.

Well, being a beta version, it may contain some errors. In general, you should be able to start the diagnostic exam by clicking the

button. If not, you *might* be able to do that after changing your screen resolution to 1024 by 768 pixels and then restarting the software. I'll look into this problem with the next release

After installing examlab6 beta in windows7. i am getting this error.
error in accessing system registry.

Sanjay Izardar wrote:After installing examlab6 beta in windows7. i am getting this error.
error in accessing system registry.

right-click setup file > properties > "compatibility" : tab > "run this program as administrator" : check-box > ok
Run setup again.

or try running from win xp inside virtual box : requires some work and "research".

hth.
good luck for the exams.

PS : Viruses easily accessed my registry but poor ExamLab could not !

Ida Achi wrote:
Devaka,

I was too quick to write that it works. Now I'm on the simulator's front page where on the right are Diagnostic exam, Practice exams and final exam. I want to start with the diagnostic exam, I click on it and nothing happens. On the left I get questions like "What do you think about out software?..." and Thank you for using Exam Lab. How does this software work?

Thanks.

First, thank you very much, Devaka!

Second, I know this is an old thread but I had the same problem as Idi Achi and found I could get Examlab.exe to work on one
of my systems.

If you consider the Diagnostic exam button as the center of clock face, the Diagnostic exam would start
if I clicked not on that button, but instead in the 4 o'clock area, about an inch away, i. e. about 30 degrees below an imagined
positive x-axis. This was on an old Windows XP SP3 system, set to 1024 x 768 resolution.

On a up-to-date 64-bit Windows 7 system, even after after installing it as administrator and running it as administrator, I couldn't
get past the "Error accessing windows registry" message that has been mentioned here:

http://www.coderanch.com/t/538765/java-programmer-SCJP/certification/Examlab-error-accessing-windows-registry

I could get this far only by setting the application to Windows Vista SP2 compatibility. If I didn't run it in compatibility mode,
I would get the other error about being unable to access "internal system files."