Hi,
I was going through the resources available for the exam practice.
I used trial exam simulator of Examhouse's practice exams.
It consists 30 questions and 15 from those I thought are use less and having no relevant to current format and type of
SCEA exam.
Questions I have seen were:
1.Which layer of switching makes no modification of the data packet?
a.Layer 2
b.Layer 3
c.Layer 4
d.MLS
2.What are the two ways to configure VLAN memberships?
a.VTP Database
b.Dynamic
c.Static
d.DHCP Server
3.In which of the following STP state on port can send and receive BPDUs, learn MAC address and send and receive Data?
a.Blocking
b.Listening
c.Learning
d.Forwarding
4.In which of the router redundancy protocols Virtual router MAC address is defined in the Form of 00000.5e00.01xx?
a.HSRP
b.VRRP
c.GLBP
5.Which of the following command is used to configure the 802.1q trunk encapsulation?
a.Switch(config)# switchport dot1q trunk encapsulation
b.Switch(config)# switchport trunk encapsulation dot1q
c.Switch(config)# switchport trunk dot1q encapsulation
d.Switch# switchport trunk encapsulation dot1q
6.Type in the command to enable STP on VLAN 4
a.Fill in the blanks -----------------
7.Type in the command to define trunking on a port to a Cisco IP phone
a.Fill in the blank: ---------------------
8.The default communication mode for 100 Mbps is half duplex
a.True
b.False
9.Which of the following functions can a Multilayer Switch perform?
a.Layer 2 Switching
b.Layer 2 Bridging
c.Inter VLAN Routing
d.Inter VLAN Switching
10._____________ is a congestion avoidance method, which unconditionally drops packets when a queue is full?
a.Fill in the blanks: ____________
11.Static VLAN offer MAC address based membership?
a.True
b.False
12.Which of the following command verifies active trunk parameters?
a.Show interface �type� mod/num switchport
b.Show interface �type� mod/num trunk
c.Show interface trunk �type� mod/num
d.Show interface switchport �type� mod/num
13.Cisco catalyst 2950 supports ISL encapsulation?
a.True
b.False
14.The default port-priority for all switch ports is _______?
a.Fill in the blanks: _______________
15.What are the criteria that STP uses to choose a path?
a.Lowest Bridge ID
b.Highest Bridge ID
c.Lowest Sender Port ID
d.Highest Sender Port ID
All the SCEA gurus please tell me that is there any possibility of getting these kinds of questions in the main exam (part I)?
I think NO. Please correct me if I'm wrong.
I think these questions are much like core networking type of questions.
When I searched for the same topic on
Java Ranch.
I found this link, which is also supporting what I said.
https://coderanch.com/t/154943/java-Architect-SCEA/certification/Part-Practice-Questions-Sim Thanks for your reply.
